Table of Contents
Advertisement
2
1
THROTTLE CABLE ADJUSTMENT
3 - 10
2. Adjust:
• Clutch lever free play
Clutch lever free play adjustment steps:
• Loosen the locknut 1.
• Turn the adjuster 2 until free play a is
within the specified limits.
• Tighten the locknut.
Locknut:
4 Nm (0.4 m · kg, 2.9 ft · lb)
NOTE:
• Make minute adjustment on the lever side
using the adjuster 3.
• After adjustment, check proper operation of
clutch lever.
EC35A001
THROTTLE CABLE ADJUSTMENT
1. Check:
• Throttle grip free play a
Out of specification → Adjust.
Throttle grip free play a:
3 ~ 5 mm (0.12 ~ 0.20 in)
2. Adjust:
• Throttle grip free play
Throttle grip free play adjustment steps:
• Slide the adjuster cover.
• Loosen the locknut 1.
• Turn the adjuster 2 until the specified free
play is obtained.
• Tighten the locknut.
Locknut:
4 Nm (0.4 m • kg, 2.9 ft • lb)
NOTE:
Before adjusting the throttle cable free play,
the engine idle speed should be adjusted.
WARNING
After adjusting the throttle cable free
play, start the engine and turn the han-
dlebar to right and left and make sure
that the engine idling does not run faster.
INSP
ADJ
Advertisement
Table of Contents
Need help?
Do you have a question about the WR450F(W) and is the answer not in the manual?
Questions and answers
Crosed back light wires now theirs no power what halve I done
Check the LED taillight for proper operation. If it does not light up, replace the taillight assembly. Also, inspect the battery connections to ensure they are secure. Be cautious when using jumper leads, ensuring they have the same capacity as the battery leads to avoid burning. Additionally, check for any blown fuses or damaged wiring that may have resulted from crossing the wires.
This answer is automatically generated