Yamaha SRCD User Manual page 22

CHAPTER2 PROFIBUS Unit
OUTPUT (Slave→Master)
Address
Im+4.0 SO216
Im+4.1 SO217
Im+4.2 SO218
Im+4.3 SO219
Im+4.4 SO220
Im+4.5 SO221
Im+4.6 SO222
Im+4.7 SO223
Im+5.0 SO224
Im+5.1 SO225
Im+5.2 SO226
Im+5.3 SO227
Im+5.4 SO228
Im+5.5 SO229
Im+5.6 SO230
Im+5.7 SO231
Im+6.0
Not Used
to Im+7.7
* Use Im.0 to Im+1.7 as dedicated outputs, Im+2.0 to Im+5.7 as general-purpose out-
puts, Qn.0 to Qn+1.7 as dedicated inputs, and Qn+2.0 to Qn+5.7 as general-purpose
inputs.
* Im+6.0 to Im+7.7 and Qn+6.0 to Qn+7.7 are not used.
! CAUTION
• The above profile is for cases where the I/O assignment selection parameter is
set to "Type 0: Conventional type" when the controller has an I/O assignment
function. For information on the profile when the I/O assignment selection pa
rameter is set to another type, refer to "2-9-2 I/O assignment list".
• The zone output is supported by the following controller versions:
ERCX, SRCX : Ver. 13.50 or later
SRCP, SRCD : Ver. 24.00 or later
Remote Register (Word I/O)
OUTPUT (Slave→Master)
Address Description
IWm+8 Status
IWm+10 Reserved
IWm+12
IWm+14
IWm+16 Command response
IWm+18
IWm+20
IWm+22
* For details on the remote register, refer to "2-12 Remote Command".
What each code means:
Codes used above are written on the basis of the digital I/O address designated in a
master manufactured by Siemens.
I : Input address
Q : Output address
m, n : Start address assigned by hardware configuration
Signal Name
Default
-
0
0
16
INPUT (Master→Slave)
Address Signal Name
Qn+4.0 SI216
Qn+4.1 SI217
Qn+4.2 SI218
Qn+4.3 SI219
Qn+4.4 SI220
Qn+4.5 SI221
Qn+4.6 SI222
Qn+4.7 SI223
Qn+5.0 SI224
Qn+5.1 SI225
Qn+5.2 SI226
Qn+5.3 SI227
Qn+5.4 SI228
Qn+5.5 SI229
Qn+5.6 SI230
Qn+5.7 SI231
Qn+6.0
Not Used
to Qn+7.7
DRCX : Ver. 18.50 or later
SRCP30 : Ver. 24.30H or later
INPUT (Master→Slave)
Address Description
QWn+8
Execution command
QWn+10
QWn+12
QWn+14
QWn+16 Command option
QWn+18
QWn+20
QWn+22
Default
0
0