Setting Procedure And Modes - Panasonic LightPix AE20 User Manual

4.4.2 Setting Procedure and Modes

Inspection is performed following the steps below:
1 Set up devices.
2 Turn the LightPixAE20 on.
Configure the
3
LightPixAE20
(in CONFIGURATION mode)
Run a teaching
4
(In TEACHING mode)
Set judgement criteria
5
(In JUDGEMENT CRITERIA
SETTING mode)
Execute an inspection
6
(In RUN / RUNVIEW mode)
There are mainly four modes available for the LightPixAE20. The settings that you can make vary depending
on the mode. To switch the modes, follow the instructions below.
Install the main unit, and connect to a power supply unit,
each unit and external devices.
Apply 24 V DC.
Set up the LightPixAE20 system in CONFIGURATION
mode. Hardware settings of the unit, output method of
reading data, saving method of captured images and other
inspection conditions.
In the TEACHING mode, register edge direction and
distance, at the same time, set the exposure time or range
for measuring area (inspection area), and area for setting
extraction color.
In JUDGEMENT CRITERIA SETTING mode, set the
allowable limits of edge distance for teaching execution.
Press the TRIGGER button in RUN (RUN VIEW) mode.
Section 3
---
Page 62
Page 64
Page 68
Page 69
61