Panasonic LightPix AE20 User Manual page 50

Checking inspection data
The number in < > in the table below represents the button number of the o
unit (see the figure on the right).
Color Area Color Area
When inspecting in RUN mode, you can check the area value. When inspecting in RUN mode, you can check the area value.
Data display
and product
type switch
Top line: Product type number
The <3>, <4> and <5> buttons: Changes the product types. Once you change them, the
signals of OUT1 to 3 are reset.
Bottom line: Area value
Area value: Up to four digits* including the numbers under the decimal point *
(The digits under the decimal point differs depending on the type of unit.)
Color Judgement Color Judgement
When inspecting in RUN mode, you can check the selected product type No. and measured area value. When inspecting in RUN mode, you can check the selected product type No. and measured area value.
Data
Display
Top line: Product type numbers (1 to 7)
Bottom line: Area value
Area value: Up to four digits* including the numbers under the
decimal point
(The digits under the decimal point differs depending on the type of
unit.)
*The range of area values
Unit
ANE2000
Data
Area value 0 to 3.20
ANE2010 ANE2020
0 to 80.00 0 to 750.0
peration
ANE2030
0 to 5600
43