A List Of Error Codes - Panasonic LightPix AE20 User Manual

6.2.4 A List of Error Codes

Error Error type
code
40H BCC
41H FORMAT
42H NotSurpport
61H DATA
62H REGIST
63H MODE
66H ADDRESS
Description
A BCC error occurred in a command data.
Headers or command start marks are out of range.
•
Header: % or <
•
Command start mark: #
The data exceeding the upper limit was sent.
•
For header "%",
The number of characters between a header and terminator exceeded 118.
For header "<"
The number of characters between a header and terminator exceeded 2048.
The numbers specified as a head and terminal word numbers do not match the
numbers of the following data.
Unsupported command was sent.
Head word No. is not less than or equal to terminal word No.
Head or terminal word No. is not specified in decimal numbering system.
In WD command, writing data are not specified in hexadecimal numbering system.
In WD command, a number out of the range specified by each command
Eg, 0 or a value more than 8 was specified as initial product type.
In WD command, when specifying start/end point and min./max. by using the
command only one time, for example, if the start point in the area to be changed ≧
the preset end point, these values should be reversed. When moving the area and
changing the preset max./min. value largely, send the values by using the command
each time.
Address out of the range specified by each command is assigned.
For example, the addresses for reading area setting are within the range from 2200
to 2227, but an address between 2201 and 2228 is assigned.
In WD command, the LightPixAE20 cannot receive the command. E.g., the WD
command was sent in CONFIGURATION mode.
The number of the connected main unit does not match that of the main unit
specified by the command.
113