Table of Contents
Advertisement
4.3.3 CONFIGURATION mode
In CONFIGURATION mode, you can set up the main, operation, and finder units,
and save the settings. The setting items available in this mode are as follows:
The number in < > in the table below represents the button number of the operation
unit (see section 4.7, "Detailed Functions in CONFIGURATION Mode").
Function
Upper: Function name and options
to be displayed
Middle: Name
Lower: Description
Display when starting
I.SETT: (CANCEL / SET)
Initial Setting (default):
Initializes the settings
SAVE: (CANCEL / SAVE)
SAVE function:
Saves the current settings
TEACH: (OK / OKNG)
Teaching: OK only/OK&NG:
B.L.PTN:
(ON/OFF10/OFF30/OFF60)
Backlight Pattern function:
Sets the backlight of the finder unit
OFF
L.ON.OF: (ON / OFF)
LED On/Off function:
Allows you to select whether or not
to use the built-in LED light
V.IMG1 ~ 8:
V.Image1 ~ 8:
Displays up to eight saved images
and the data detected when the
image was saved
SV.IMG: (OFF / ALL / NG)
Save Image function:
Saves images during inspection
A.SAVE: (ON / OFF)
Auto Save function:
Allows you to set to save the
settings automatically
Display on the operation unit
The left LCD display shows default settings.
(
↑When the image is saved, the detection data are
displayed. When switching the image numbers, hold down the <7> and
<8> button.
)
If you want to initialize the settings,
select "SET" and press the <6> button
for approximately three seconds.
If you want to save the settings, select
"SAVE" and press the <6> button for
approximately three seconds
Allows you to select whether you want
to execute a teaching for OK products
only or both OK product and NG
product
49
Advertisement
Table of Contents
