Setting Up The Meters; Activating For The First Time - Yamaha 6Y8- 2819U-00 Owner's Manual

Activating for the first time

5. Setting up the meters

To install the meters and the optional sen-
sors and to connect the meters to the
engine, see the "Command Link Multifunc-
tion Meter Installation Manual."
Be sure to follow the procedures in "Activat-
ing for the first time" and "Setting the initial
settings." If the procedures are performed
incorrectly, the engine number will change,
resulting in improper operation.
1. Installing the meters
2. Connecting the meters to the engine
3. Installing an optional sensor
4. Activating for the first time
5. Setting the initial settings
If the procedures are performed incorrectly,
see "Service functions" in "1. Tachometer
unit" to reset all of the engine numbers.
Check the connections, and follow the setup
procedures again to set up the meters.
Activating for the first time
After installing the meters, be sure to turn
the engine start switch to ON when the
power is supplied for the first time. When
multiple outboard motors are installed, be
sure to turn the engine start switch to ON
from the port outboard motor and to wait at
least 2 seconds before turning each engine
start switch to ON.
NOTE:
• The engine number of the engine whose
engine start switch was first turned to ON
is stored in the ECM (Engine Control Mod-
ule) of the engine as the port engine
(engine number 1).
• To reset an engine number, see "Reset-
ting engine number" under "Service func-
tions" in "1. Tachometer unit."
63