Cooling water pressure display/Water detection warning
Cooling water pressure display
(optional: cooling water pressure sensor
has been installed)
The cooling water pressure indicator (
comes on and the cooling water pressure is
shown in 5 levels. You can select whether to
display the scale.
CAUTION:
• When the cooling water pressure
decreases to 10 psi or less, turn the
engine off and check the cooling water
inlet for clogs.
• If you cannot locate and correct the
cause, consult a Yamaha dealer.
NOTE:
The cooling water pressure level display
shows "L" for low and "H" for high.
)
10 PSi
9
Water detection warning
When water has accumulated in the water
separator (fuel filter), the water detection
warning indicator (
FUEL" warning blink. This function is not
available for outboard motors that are not
equipped with the water detection warning
function.
Blink
CAUTION:
When the water detection warning comes
on, turn the engine off and remove the
water from the water separator (fuel fil-
ter) by following the procedure described
in the Owner's Manual of the outboard
motor. A malfunction can result if fuel
mixed with water is sent to the engine.
NOTE:
or
: To deactivate the buzzer
and return to the display before the warning
was activated.
) and the "WATER IN