Daily Inspection And Maintenance; Inspection - Canon TX-F Operation Manual

8. Daily Inspection and Maintenance

CAUTION
!

8.1 Inspection

In order to ensure that the instrument is used safely and normally, please be sure to inspect
the instrument before use.
If any problem is found during the inspection, please take measures indicated in this chap-
ter. If problem still cannot be corrected, please contact Canon representative or distributor.
WARNING
!
8.1.1 Before Turning ON the Power
WARNING
!
WARNING
!
It is recommended that a record of the inspection be kept by copying this and the next
page, or making a separate check list.
Inspection
(1) Check that cable is not dam-
aged or cover of cable is not
torn.
(2) Check that the power cable
is inserted fully into the connec-
tor on the instrument and into
the AC receptacle.
For safety reasons, be sure to inspect the instrument daily before using it.
The instrument must be repaired by a qualified engineer only.
If it is not repaired properly, it may cause fire, electric shock, or
accident.
For safety reasons, be sure to turn OFF the power switch when
the following inspections are going to be performed.
Otherwise, it may result in electric shock.
Clean the plug of the power cable periodically by unplugging it
from the AC outlet and removing dust or dirt from the plug, its
periphery and AC outlet with a dry cloth.
If the cable is kept plugged in for a long time in a dusty, humid or
sooty place, dust around the plug will attract moisture, and this
could cause insulation failure which could result in a fire.
Date
/
Good/
Bad
Good/
Bad
Result
Date Date
/ /
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
– 43 –
Remedy
Contact Canon or distributor if
there is any problem.
Fully insert the cable.