Canon TX-F Operation Manual page 36

5.2 FULL AUTO/AUTO Measurement
The result is printed out
9
FULL AUTO mode
If "
printed out automatically after both eyes are measured.
If "
AUTO mode
Press
Press
(If the switch is pressed for more than two seconds, air will be emitted from the
nozzle for demonstration of air puff.)
Measurement values of both eyes will be deleted from the monitor and serial num-
ber will count up if "
However, measurement data remains in memory until the next measurement is per-
formed. Data in memory can be seen in DISPLAY mode (see section 6).
Also, data will be printed if
NOTES: 1. Results will be erased from the monitor after printing/transfer is per-
Serial number
Space for name
Measurement values
Standard value
Optional message
Measurement head returns to initial position
10
When printing is completed, the measurement head returns to its initial position
and waits for the next measurement.
" and "
PRINT AUTO PRINT
AUTO PRINT " is " OFF
switch.
PRINT
If printing is unnecessary after the measurement
CLEAR (DEMO) switch for an instant.
COUNT
formed. Serial number will count up if "COUNT" is set to "ON" in
SET mode.
2. It is recommended that a hard copy of the printout be made if you
wish to store it for a long time, because printouts on the thermal
paper are apt to deteriorate.
CANON TX-F
Date
2004/01/20
No. : 000001
NAME:
IOP -SEQUENCE- mmHg
RIGHT
11
12
12
[ 11.7
CANON CLINIC
" are set to " " in SET mode, the result will be
ON
", press PRINT switch.
" is set to " " in SET mode.
ON
PRINT switch is pressed.
Time
14:25
Sex
M/F
Type of result
STANDARD: Only the standard value
LEFT
RELIABIL: The three values with the
12
highest reliability
14
SEQUENCE: The three newest values
15
Level meter
13.7 ]
(Printed when setting in SET mode is
ON)
– 26 –