Canon TX-F Operation Manual page 40

5.3 MANUAL Measurement
Repeat the measurement as many times as required
8
NOTE: It is recommended that the measurements be repeated at least three to five
Repeat alignment and measurement as many times as required. Maximum of 10
data can be saved in memory.
Measure the eye
9
Press
Measure the eye
10
Measure the left eye in the same way as measuring the right eye.
Print/transfer the result
11
Press
Instrument will return to the measurement mode (FULL AUTO or AUTO)
selected for "
Press
(If the switch is pressed for more than two seconds, air will be emitted from the
nozzle for demonstration of air puff.)
Measurement values of both eyes will be deleted from the monitor and serial num-
ber will count up if "
However, measurement data remains in memory until the next measurement is per-
formed. Data in memory can be seen in DISPLAY mode (see section 6).
Also, data will be printed if
NOTES: 1. Results will be deleted from memory at the measurement after print-
times in order to obtain most reliable measurement.
R/L switch in order to move the measurement head toward the other eye.
PRINT switch.
DEFAULT " in SET mode.
If printing is unnecessary after the measurement
CLEAR (DEMO) switch for an instant.
COUNT
ing/transfer is performed.
2. It is recommended that a hard copy of the printout be made if you
wish to store it for a long time, because printouts on thermal paper
are apt to deteriorate.
" is set to " " in SET mode.
ON
switch is pressed.
PRINT
– 30 –