Touch Panel Adjustment; Security Setup - Kenwood DNX7280BT Instruction Manual

Touch panel adjustment

1
Touch [Touch] in the System Menu
screen.
Touch Panel Adjustment screen appears.
2
Follow the instruction on the screen
and touch the center of each
NOTE
• To cancel the touch panel adjustment, touch
[Cancel].
• To reset to the initial status, touch [Reset].

Security setup

operation
You can set up a security code to protect
your receiver system against theft.
NOTE
• When the Security Code function is activated, the
code cannot be changed and the function cannot
be released. Note the Security Code can be set as
the 4 digit number of your choice.
1
Touch [Security] in the System Menu
screen.
Security screen appears.
2
Touch [ON] of [SI].
.
NOTE
• If "SI" is turned on, the SI indicator on the sub
panel flashes when the vehicle ignition is off and
the panel is detached. Default is "ON. "
3
Touch [SET] of [Security Code Set].
NOTE
• If you have already completed the code
registration, [CLR] is displayed.
4
Enter a security code with four-digit
number and touch [Enter].
5
Enter the same code again and touch
[Enter].
Security code is registered.
NOTE
• If you enter a different security code, the screen
returns to step 4 (for the first code entry).
• If you have pressed <Reset> button or if you
have disconnected the Receiver from battery,
enter the correct security code as that you have
entered in step 4 and touch [Enter]. You can use
your Receiver.
operation
A red indicator will blink on the unit after the
ACC is set to OFF, warning potential thieves.
If turned to "ON" (default), the security
indicator on the front panel flashes when the
vehicle ignition is off.
1
Touch [Security] in the System Menu
screen.
Security screen appears.
2
Touch [ON] or [OFF] of [SI].
Return to the Top page
Setting Up
69