Connecting The Bluetooth Unit - Kenwood DNX7280BT Instruction Manual

Registering the Bluetooth Unit
1
Touch [SET] of [Regist New Device].
Searched Device List screen appears.
NOTE
• A new device cannot be registered if there are 5
registered Bluetooth units. Delete unnecessary
registration. See Connecting the Bluetooth
unit (P.53).
• If a Bluetooth unit cannot be registered by normal
register (pairing) operation, touch [SP DEV]. For
details, see Registering special Bluetooth unit
(P.54).
2
Touch [PIN Code Set].
PIN Code Set screen appears.
NOTE
• If the unit cannot be searched in step 1, you can
search the unit again by touching [Search] in
above screen.
• Touch [Cancel] to cancel searching for the
Bluetooth unit.
3
Enter PIN code and touch [Enter].
The entered code is recognized and
Searched Device List screen appears again.
4
Select the Bluetooth unit to register
from the list.
The Connection Device List screen appears.
NOTE
• Registering operation can be performed from the
Bluetooth unit. In this operation, entering the PIN
code is necessary. See Registering Bluetooth
unit PIN code (P.59).
• If registering cannot be completed even when
the PIN code is correct, try Registering special
Bluetooth unit (P.54).

Connecting the Bluetooth unit

1
Touch [SET] of [Paired Device List].
Connection Device List screen appears.
2
Touch the device name you want to
connect.
Means that the device is a cell-phone.
Means that the device is an audio player or
cell-phone with audio player.
NOTE
• If the icon is lighted, it means that the unit will
use that device.
3
Touch [TEL(HFP)] or [Audio(A2DP)].
[TEL(HFP)] is for cell-phone.
[Audio(A2DP)] is for audio player.
NOTE
• [Audio(A2DP)] is available only for
• Touching [Remove] removes registration
information. After you touch the key, a
confirmation message appears. Follow the
message and complete the operation.
• To disconnect the device, perform above
procedures again.
Return to the Top page
Bluetooth Operation
.
53