Chapter 3 Installation
>
3.2 Rack Installation
8
3.2.2
Installing Drive Enclosure
This section describes how to install the drive enclosure in a rack.
IMPORTANT
P3AM-3042-03ENZ0
ETERNUS DX60/DX80 Disk storage system User Guide
Replace the front cover.
Refer to
"2.2.3 Attaching and Removing the Front Cover" (page 58)
replacement procedure.
Electric Shock
WARNING
•
For these operations, be sure to turn off the device connected to the
ETERNUS DX60/DX80 (such as servers) when it is turned on, and
remove the power cord from the outlet or it may lead to electronic
shock.
Do Not
CAUTION
•
RAID groups, volumes, and hot spares are factory set. Disks which
contain RAID groups or volumes, or disks which are hot spares
should not be moved to another slot.
When installing multiple drive enclosures, install them on the controller
enclosure in order of the "DE_No. label" attached on the drive enclosure.
The "DE_No. label" is attached in the following location.
At the right side of the
front of the drive enclosure
Between the EXP#0 and EXP#1 expanders
at the rear of the drive enclosure
DE_No. label
71
for the front cover
End of procedure
Copyright 2009 FUJITSU LIMITED