Fujitsu Eternus DX60 User Manual page 88

Chapter 4 Setup
> 4.2 Cable Connection
Fibre Channel cable connection procedure
The following explains how to connect the Fibre Channel cable.
IMPORTANT
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
• Fibre Channel cable is thin and breaks easily, so be careful not to
CAUTION
pinch the cable between devices or bend it too much. Keep a 30mm
or larger radius when bending Fibre Channel cable. Failure to do so
may cause device damage or failure.
When connecting the Fibre Channel cable, check the direction of the
connector tab and insert it all the way in firmly.
When disconnecting the Fibre Channel cable, pull out the connector while
holding its tab.
This section describes dual controller model as an example. Note that there
is only controller 0 (CM#0) for single controller model.
30mm
or larger
90˚
Do not bend square
88
Do not bind up
Copyright 2009 FUJITSU LIMITED