Chapter 4 Setup
>
4.3 ETERNUS DX60/DX80 Setup
5-2
6
6-1
6-2
P3AM-3042-03ENZ0
ETERNUS DX60/DX80 Disk storage system User Guide
Figure 4.12 [Setup Network Environment] screen
A confirmation screen appears.
Click the [OK] button.
The Network Environment is set, and the [Finish] screen appears.
Finish the initial setup.
Click the [Finish] button.
Figure 4.13 [Finish] screen of the initial setup
The [Initial Setup] completes.
Device setting operation cannot be continued if the IP address is
IMPORTANT
changed. Logon again with the new IP address is required.
Remove the LAN cable (for operation management) from the PC that is to be used to
set up the ETERNUS DX60/DX80, and connect the LAN cable (for operation
management) of the MNT port of Controller 1 (CM#1) and Controller 0 (CM#0) to the
customer's network.
119
Copyright 2009 FUJITSU LIMITED