Chapter 3 Installation
>
3.2 Rack Installation
3.2.1
Installing Controller Enclosure
This section describes how to mount the controller enclosure in a rack.
Procedure
1
2
P3AM-3042-03ENZ0
ETERNUS DX60/DX80 Disk storage system User Guide
Warning
WARNING
•
For these operations, be sure to turn off the device connected to the
ETERNUS DX60/DX80 (such as servers) when it is turned on, and
remove the power cord from the outlet or it may lead to electronic
shock.
Do Not
CAUTION
•
RAID groups, volumes, and hot spares are factory set. Disks which
contain RAID groups or volumes, or disks which are hot spares
should not be moved to another slot.
Refer to "ETERNUS DX60/DX80 Disk storage system Package Contents" to
confirm there are no missing parts for the rack mount kit.
"ETERNUS DX60/DX80 Disk storage system Package Contents"
Refer
Adjust the rack rails (bracket L (for left side) and bracket R (for right side)) sizes
to fit the rack.
Reposition the M4 screws to adjust the length of the rack rails (brackets) to match the
distance between the front and rear rack pillars. Leave the M4 screws slightly unscrewed,
as the bracket must be attached to the rack before they can be completely tightened.
68
Copyright 2009 FUJITSU LIMITED