Yamaha RX-V673 Owner's Manual page 43

Error messages
If any error message is displayed during the measurement, resolve the problem and perform YPAO again.
E-1 : No Front SP Front speakers are not detected.
E-2: No Sur. SP One of the surround speakers cannot be detected.
E-3: No F.PRNS SP One of the presence speakers cannot be detected.
E-4: SBR > SBL A surround back speaker is connected to the R side only. When using only one surround back speaker, you need to connect it to the SINGLE jack (L side). Follow the
on-screen instructions to exit YPAO, turn off the unit, and then reconnect the speaker.
E-5: Noisy The noise is too loud. Keep the room quiet and follow the on-screen instructions to start the measurement again. If you select
"PROCEED", YPAO takes the measurement again and ignores any noise detected.
Surround back speakers are connected, but no surround Surround speakers need to be connected in order to use surround back speakers. Follow the on-screen
E-6: Check Sur.
speakers are connected instructions to exit YPAO, turn off the unit, and then reconnect tile speakers.
Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the
E-7: No MIC The YPAO microphone has been removed.
measurement again.
Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the
E-8: No Signal The YPAO microphone cannot detect test tones, measurement again. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service
center.
E-9: User Cancel The measurement has been canceled. Follow the on-screen instructions to start the measurement again. To cancel the measurement, select "EXIT".
Follow the on-screen instructions to exit YPAO, turn off and on the unit. If this error occurs repeatedly, contact
E-10: Internal Error An internal error has occurred.
the nearest authorized Yamaha dealer or service center.
Follow the on-screen instructions to exit YPAO, turn off the unit, and then check the speaker connections.
PREPARATIONS • Optimizing the speaker settings automatically (YPAO) En 43