Connecting - Yamaha RX-V673 Owner's Manual

Connect the supplied FM/AM antennas tothe unit.
Fix the end ofthe FM antenna toawall, and place t he AM antenna onaflat s urface.
FM antenna
AM antenna
The unit (rear)
Assembling and connecting the AM antenna
%°
Connect the unit to your router with a commercially-available STP network cable (CAT-5
or higher straight cable).
You can enjoy Internet radio or music files stored on media servers, such as PCs and
Network Attached Storage (NAS), on the unit.
Internet Network Attached Storage
(NAS)
Mobile device
(such as iPod touch
and iPhone)
Network cable
The unit (rear)
Hold down _/_ Insert _.
Release
• If you are using a router that supports DHCE you do not need to configure any network settings for the unit,
as the network parameters (such as the IP address) will be assigned automatically to it. You only need to
configure the network settings if your router does not support DHCP or if you want to configure the network
parameters manually (p.98).
• You can check whether the network parameters (such as IP address) are properly assigned to the unit in
"Network" (p.104) in the "Information" menu.
• Unwind only the length of cable needed from the AM antenna unit.
• The wires of the AM antenna have no polarity.
Some security software installed on your PC or the firewall settings of network devices (such as a router)
may block the access of the unit to the network devices or the Internet. In these cases, configure the
security software or firewall settings appropriately.
Each server must be connected to the same subnet as the unit.
To use the service via the Internet, broadband connection is strongly recommended.
PREPARATIONS • Connecting the FM/AM antennas En 32