Yamaha RX-V677 Quick Start Manual

10/6/2017
RX-V677 Setting Receiver Back to Factory Settings
Setting the reciever back to factory settings
Note: This will be done on the front panel of the receiver only.
1. Set the unit to Standby Mode using the Main Zone Power button.
2. While holding down the Straight on the front panel, press the Main Zone Power button.
3. When SP IMP -8ohms Min or SP IMP -6ohms Min comes up on the reciever panel, let go
of the straight button.
4. Press the Program Arrow Right button repeatedly to select INIT- CANCEL.
5. Press the Straight button repeatedly to select INIT- ALL.
6. Press the Main Zone Power button to turn the unit off.
http://faq.yamaha.com/us/en/article/audio-visual/av-receivers-amps/rx/rx-v677_black_u/10797/8403
RX-V677 Setting Receiver Back to Factory Settings - RX-V677 - RX-V - AV Receivers - Audio & Visual
1/2