GE 13V110TD User Manual page 15

Connections & Setup Chapter 1
6.
Look at your cane box. If it is still on and changed to
channel 09, the test was successful.Highlight Yes,and
pressOK (STEP 3: Configuring for o VCRappears).
If your cane box didn't change to channel 09 or turned
itself off, you have two choices: No and Test this code
again.
Test this code again: If you think the IV[DVD, the cane
box, or any of the remote controls might have been
touched or bumped during the test, highlight Test this
code again and pressOK (the GUIDEPlus+ system runs
the same set of codes).
No: If you don't think the test was interrupted, highlight
No and pressOK (GUIDEPlus+system tests the next
code).
Repeat the previous instructions until the IV finds the
correct cable box code. Follow the instructions on the
screen.
Note: If the W can't find your cable box code, a troubleshooting
checklist appears.C_refufly review each checklist and ratiow the
instructions on thescreen.
Step 3: Configuring for a VCR
1. If your IV/DVD is connected to a VCR,pressOK (a screen
appears reminding you to connect your G-LINK cable to
your IV/DVD and VCR).
If it is not, highlight No and pressOK (STEP4: Confirming
Your Settings appears).
2. Use the up and down arrow buttons to highlight the
brand of your VCRthat is connected to the IV/DVD and
pressOK.
If your brand isn't listed, highlight Not Listed and press
OK.
Chapter I Graphics contained within this publication are for representation onlg 13