Table of Contents
Advertisement
CONNECTION TO TV
To playback tapes recorded with your Camcorder on your TV, connect the supplied RF Converter between your TV and
the Camcorder.
Connection to normal TV.
AV out terminal
TV PLAYBACK
To view the output from your Camcorder on the TV,
you must select an unused channel on your TV and
tune to the output of the supplied RF converter
(factory preset to CHO).
1
Remove the antenna cable from your TV
and then connect the supplied RF converter
between the Camcorder and the TV as
shown above and then plug the antenna
cable into the ANTENNA IN terminal on
the RF converter.
Set the Camcorder CAMERA RECNCR
slide the OPERATE switch to ON.
Press the EJECT button and insert a record-
ed video cassette and press the PLAY
button.
Select an unused channel on the TV and
tune it to the output of the RF converter
(factory preset to CHO) until a good coloured
playback picture of the inserted video tape
is obtained.
To resume normal broadcast viewing on
the TV, slide the OPERATE switch to OFF
on the Camcorder and select the normal
channels on the TV tuner.
26
The supplied RF converter permits playback of video/audio
signals through a normal TV. The
to CHO.
Connected to outdoor
or
indoor antenna or cable
RF converter (supplied)
RF
converter channel select switch
through a TV receiver. The signals from the RF unit are
viewed through a vacant channel not used for broadcast-
ing in your area.
*The RF converter is factory preset to CHO. If CH0 is used
in your area, set the CHANNEL switch on the RF converter
to the CH1 position and then retune your TV as shown
above.
convener is factory set
RF
Advertisement
Table of Contents
