Table of Contents
Advertisement
CHARGING
THE BATTERY PACK
Use the supplied AA-75X AC Adaptor/Battery Charger.
Car Battery Adaptor/Charger.
1
Insert the AC plug in a power point.
The OPERATE lamp will light
Align the v mark on the side of the battery
pack with I mark on the charger and guide
the battery pack into the groove. Slide the
battery pack fomard until it locks in place.
The CHARGE lamp will light up.
USING THE CAR BATTERY ADAPTOR/CHARGER (OPTIONAL ACCESSORY)
To charge the battery pack or power the Camcorder in a car, use the optional SHARP VR-P75CH Car Battery Charger.
1
Start the car engine and leave it idling
while using the Car Battery Charger.
Insert the plug into the car cigarette socket.
The OPERATE lamp will light up.
Connect the DC OUT cable to supply power
to the Camcorder.
The CHARGE lamp will be lit up while the
battery pack is charging. When charging is
completed, the CHARGE lamp will go off,
and the DONE lamp will light up.
The VR-P75CH Car Battery Adaptor/Charger will not
supply power to the Camcorder through the DC
while charging a battery pack.
12
Outdoors, you can use the optional SHARP VR-P75CH
When the battery pack is charged the
CHARGE lamp will go off. Pull out the
up.
AC plug from the wall outlet and remove
the battery pack by 'sliding it back.
L
Normally the battery pack and charger are warm after
charging.
The charging time depends on the amblent temperature
and the condition of the battery pack.
Caution:
The VR-WSCH Car Battery Charger can only be used
OUT cable
with 12V or 24V negative-ground cars.
Do not use with 12V or 24V positive-ground cars. Check
the car operation manual or consult your car dealer.
Advertisement
Table of Contents
