STYLUS 800 Service Manual
CASE, UPPER Removal
3.2.1
Remove the COVER, PRINTER by releasing the tabs holding it to the CASE, UPPER.
[Step 1]
[Step 2]
Remove the SUPPORT, PAPER by releasing the tabs holding it to the CASE, LOWER.
[Step
Remove the GUIDE, PAPER, REAR.
3]
[Step
Remove the CONTROL PANEL. (Release the tab by inserting a screwdriver into the hole
4]
in the CASE, UPPER, as shown in figure below.)
Remove 2 screws (CBB screw (M3 x 12) x 2).
5]
[Step
[Step
Release 3 tabs by inserting a flathead screwdriver into the holes at the bottom of the
6]
CASE, LOWER, as shown in figure below.
Holds the upper case firmly and pulling it as to remove, while you releasing the tabs.
[Step 7] Remove the CASE, UPPER by lifting the front side.
Rev. A
Figure 3-2. CASE, UPPER Removal
Disassembly and Assembfy
3-3