Disassembly and Assembly
Power Supply Unit (C106 PSB/PSE BOARD) Removal
3.2.2
Remove the CASE, UPPER. (Refer to Section 3.2.1.)
[Step 1]
Disconnect the cables from comectors CN1 and CN2 of the C106 PSB/PSE BOARD.
[Step 2]
Remove 4 screws (CBB screw (M3
[Step
3]
fixing the power supply unit to the lowercase, as shown in figure below.
Push in the locking tab and take out the power supply unit by sliding it toward the back
[Step
4]
of the printer.
Figure 3-3. POWER SUPPLY UNIT Removal
3-4
CBS screw (M3
x 6) x 2,
STYLUS 800 Service Manual
6), CB(0) screw (M4 x 8))
x
Rev. A