TeamPoS 3000 XL and XL
7.11 Replacing the Power Supply
1. Remove the back panel (See Section 5.1.2).
2. Disconnect the power cable from the controller.
3. Remove the front panel (See Section 5.1.1). The yellow LED light should be off (See
Section 1.2).
4. Unseat the motherboard.
5. Remove the backplane assembly (See Section 7.8).
6. Unseat any installed I/O boards. It is not necessary to disconnect the cables, just remove
from the chassis to allow access to one of the mounting screws and the power supply
cables.
7. Remove the 3 mounting screws. Retain the screws.
Screw #1
Viewed from front of
Power Supply
D900000145
2
Screw #2
Screw #1
Viewed from rear of Power
From Rear
Supply
Issue 3
Maintenance
Screw #3
Viewed from side of
Power Supply
7-53