Power On And Off Sequence - Fujitsu TeamPoS 3000 XL Installation & Maintenance Manual

TeamPoS 3000 XL and XL
5. If the keyboard or LCD has the MSR option installed, pass a magnetic
stripe reader cleaner through the magnetic stripe reader to remove dust
particles from the reader. The cleaner is a card covered with cloth on one
side. Pass the card through the reader with the cloth side facing the MSR
head. An embossed arrow on the keyboard shows where the MSR head is
located.
6. Never remove covers from the control unit and peripherals while power is
connected.
7. Keep the rear cover of the TeamPoS 3000 terminal installed at all times
unless the terminal is being serviced. The cover protects the cable
connections and ensures adequate clearance for proper ventilation.
8. Make sure all cable connectors are securely installed on the terminal and
peripherals to prevent the cables from being accidentally pulled off.
Disconnecting and connecting cables (except USB cables) to the terminal
while the power is on could cause damage to the terminal and its
peripherals.
9. Do not expose the terminal to liquids. Although the units are designed to
resist liquids from entering the internal components, liquids should be kept
away from the terminal.

6.1.2 Power ON and OFF Sequence

This section presents the general procedures for powering the TeamPoS 3000 control unit
ON and OFF. The instructions in this section assume that the terminal, operating system,
and the application software have been installed. For any additional power on and off
procedures dictated by the retail application, refer to the manuals provided with your PoS
and application software.
Caution: With the exception of USB peripherals, never remove or
D900000145
2
connect any peripheral while power is on its port. To avoid
damage to the control unit and peripherals, when connecting and
disconnecting RS232 peripherals from the I/O Boards, the turn
power OFF with the ports OFF switch (see Section 1.2), the
TeamPoS 3000 power switch (in the front of the unit) or by
disconnecting AC power.
Issue 3
General Operations
6-2