Bbc Cable Removal (Recycler/Rear Bagger) - Toro 20330 - Low Wheel Walk Power Mower Service Manual

8. Slip the spring over the shaft. One tang of the spring
must engage the tab as shown (Fig. 198).
A. Idler/brake arm
9. Start the shaft into the hole in the housing. Rotate
the idler/brake arm clockwise so the upper tab on
the spring can engage the boss in the housing.
Rotate the idler/spring arm counterclockwise (Fig.
199) and push the rest of the way into the housing.
The brake pad should now ride on the brake drum.
WPM Drive Systems Manual
Fig 198 3428-0190
Fig 199 3428-0192
BBC / BOS / BCS
10. Hold the idler/brake arm in place. Slip the spring
over the end on top of the deck as shown. Install
the lever and install the screw through the lever and
idler/brake arm shaft (Fig. 200). Once the screw is
secured take a loop of wire or rope and hook the end
of the spring. Pull it towards you and hook the end
as shown.
B B
A A
A. Spring
B. Screwdriver

BBC Cable Removal (Recycler/Rear Bagger)

1. Loosen the cable clamp and pull cable out from
under the screw (Fig. 201).
C C
Fig 200 3428-0177-3
C. Wire loop
Fig 201 3428-0172
6-27