HP D6030A - NetServer - E50 User Manual page 41

Chapter 5
Code Description
twice.
0097h DiagTools Error
0098h DiagTools Error
0099h DiagTools Error
009Ah PnP function 40
failed.
009Bh Invalid number of
PnP cards.
009Ch One or more
unknown PnP cards.
009Dh No PCI bus system
device Node.
009Eh Too many PCI
busses.
009Fh DiagTools Error
00A0h PnP function 41
failed.
Recommended Action
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
Replace System BIOS.
Check all PnP devices.
1. If necessary, update the BIOS.
2. Clear the CMOS and rerun configuration. See directions on the technical
reference label or card.
3. Make sure the system board is seated.
4. Check the seating of the voltage regulator module (VRM) if present.
5. Be sure the processor board (if any) is seated.
6. Make sure the CPU chip is seated. (Take ESD precautions.)
7. Make sure the memory elements (DIMMs) are properly seated.
8. Check system fans. If overheating occurs, chip may shut down.
9. If the system ran with temperature high, let it cool for 30 minutes, then restart.
10. If system repeatedly shows this error, replace the element with the CMOS.
1. Run the BIOS Setup program and reconfigure all settings.
2. If necessary, update the BIOS.
3. Clear the CMOS and rerun configuration. See directions on the technical
reference label or card.
4. Make sure the system board is seated.
5. Check the seating of the voltage regulator module (VRM) if present.
6. Be sure the processor board (if any) is seated.
7. Make sure the CPU chip is seated. (Take ESD precautions.)
8. Make sure the memory elements (DIMMs) are properly seated.
9. Check system fans. If overheating occurs, chip may shut down.
10. If the system ran with temperature high, let it cool for 30 minutes, then
restart.
11. If system repeatedly shows this error, replace the element with the CMOS.
Download a new version of DiagTools from the HP web site and run it. If you get
the same error, call the HP Customer Care Center.
1. Run the BIOS Setup program and reconfigure all settings.
Error Message Reference
37