HP D5970A - NetServer - LCII Guía Del Usuario page 36

Chapter 4
Figure 4-2. DIMM Locations on System Board
7. Choose an empty slot on the system board to install a DIMM.
DIMMs may be installed in any combination, in any slot, but HP
recommends starting at slot 0 and filling the slots in order with the largest
size first: DIMM slots 0, 1, 2, and 3.
8. Spread the two retaining latches on the slot outward. See Figure 4-3.
CAUTION The memory modules are sensitive to static electricity and can
be easily damaged by improper handling. Do the following
when handling the accessory kit:
you are ready to install it.
container, touch a grounded, unpainted metal surface on the
HP Netserver to discharge static electricity.
30
System Board (top view)
Leave the memory module in the anti-static container until
Always use an anti-static wrist strap and a grounding mat.
Before you remove a memory module from the anti-static
Installing Additional Memory
0
DIMM
1
Slots
2
3