HP D5970A - NetServer - LCII Guía Del Usuario page 125

Chapter 13
Leveler
Screws (4)
Figure 13-4. Mounting Outer-Rails to Columns
5. With the outer-rails held in position at the rear, push in on the front
outer-rail mount.
A tension spring allows the outer-rails to compress during installation. The
outer-rails are held in place at of the front of the rack by a flat spring tab at
the rear face of the front columns. See Figures 13-2 and 13-5.
6. Repeat Steps 3 through 5 for the outer-rail assembly on the right front and
rear columns.
7. If you need to release the outer-rail assembly once installed into the rack,
do the following:
a. Place your finger inside the rail at the point shown by the arrow to
release the spring tab. See Figure 13-5.
b. Press in on the spring tab and pull the outer-rail assembly toward you at
the front of the rack. See Figure 13-5.
Alternative Rack Mounting (4–Post)
Anti-tip Foot
Extended
119