HP D5970A - NetServer - LCII Guía Del Usuario page 113

Chapter 12
7. Turn on power to the Netserver and the following message displays:
Incorrect System Configuration
8. Press <F2> to run the Setup Utility when <F2=Setup> appears.
9. Make any configuration changes required.
10. Choose the Exit option and save the changes to save the configuration and
exit the Setup Utility.
Switch 1 Position
Figure 12-1. Configuration Switch Location
Shaded rectangle
represents the position
of switch.
Figure 12-2. Configuration Switch Positions
Configuration Switch
Spring Latch Battery
Rear of Chassis
Not Used (Default = Off)
BIOS Recovery
Clear Password
Clear CMOS
Not Used (Default = Off)
Open = Off Closed = On
Troubleshooting
107