Login-Banner; Member - Dell PowerEdge M420 Reference Manual

User Guidelines
No specific guidelines.
Example
console(config)#interface out-of-band
console(config-if)#ip address dhcp

login-banner

Use the login-banner command to enable login banner on the console, telnet
or SSH connection. To disable, use the no form of the command.
Syntax
login-banner
no login-banner
MESSAGE — Quoted text
•
Default Configuration
This command has no default configuration.
Command Mode
Line Configuration
User Guidelines
This command has no user guidelines.
Example
console(config-telnet)# no login-banner

member

Use the member command in Stack Global Configuration mode to pre-
configure a switch stack member. Execute this command on the Management
Switch. To remove a stack-member configuration from the stack, use the no
form of the command.
1544
System Management Commands