Lamp Command; Cf_Lamph Command; Cf_Lampmode Command - Sanyo PDG-DXL2000 - 2000 Lumens Specifications

PDG-DXL2000 Expand Serial Command Functional Specifications

8.8 Lamp Command

8.8.1

CF_LAMPH Command

Command "CF_LAMPH_%1"[CR]
%1 "RST"
Reset Lamp use time counter.
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.8.2

CF_LAMPMODE Command

Command "CF_LAMPMODE_%1"[CR]
"NORMAL" ------- Set lamp to Normal mode status
"ECO" ------------- Set lamp to 3L mode status
%1
"UP" --------------- The same operation as pressing Up key or Left key
"DN" --------------- The same operation as pressing Down key or Right key
Select Lamp Mode
The value set by this command is stored in EEPROM and its setting is effective
Details
even after ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
32/72