Dell PowerConnect 3424 User Manual page 308

PVID (1-4093 , 4095) — Assigns a VLAN ID to untagged packets. The possible field values are 1-4095.
VLAN 4095 is defined as per standard and industry practice, as the Discard VLAN. Packets
classified to this VLAN are dropped.
Frame Type — Packet type accepted by the LAG. Possible values are:
Admit Tag Only — Only tagged packets are accepted by the LAG.
Admit All — Tagged and untagged packets are both accepted by the LAG.
Ingress Filtering — Enables or disables Ingress filtering by the LAG. Ingress filtering discards
packets that are destined to VLANs of which the specific LAG is not a member.
Current Reserve VLAN — The VLAN currently designated as the reserved VLAN.
Reserve VLAN for Internal Use — The VLAN that is designated as the reserved VLAN after the
device is reset.
Assigning VLAN LAG Settings:
1
Open the VLAN LAG Settings page.
2
Select a LAG from the LAG drop-down menu and complete the fields on the page.
3
Click Apply Changes.
The VLAN LAG parameters are defined, and the device is updated.
Displaying the VLAN LAG Table
1
Open the VLAN LAG Settings page.
2
Click Show All.
The VLAN LAG Table opens.
Assigning LAGs to VLAN Groups Using CLI Commands
The following table summarizes the equivalent CLI commands for assigning LAGs to VLAN
groups as displayed in the VLAN LAG Settings page.
Table 7-83. LAG VLAN Assignments CLI Commands
CLI Command
switchport mode {access | trunk
| general}
switchport trunk native vlan
vlan-id
switchport general pvid vlan-id
308
Configuring Switch Information
Description
Configures a LAG VLAN membership mode.
Defines the port as a member of the specified
VLAN, and the VLAN ID as the LAG default
VLAN ID (PVID).
Configure the LAG VLAN ID (PVID) when the
interface is in general mode.