Hardware Specifications; Power Requirements; Connectors; Drac 4 Ports - Dell Remote Access Controller 4 Firmware Version 1.30 User Manual

Hardware Specifications

Power Requirements

Table 1-1 lists the power requirements for the DRAC 4.
Table 1-1. DRAC 4 Power Requirements
System Power
1.2 A on +3.3 V AUX (maximum)
550 mA on +3.3 V main (maximum)
0 mA on+5V main (maximum)

Connectors

NOTE:
Installation instructions for the DRAC 4 hardware can be found in the Installing a Remote Access Card
document or the Installation and Troubleshooting Guide that comes with your system. Ensure that you
connect the management cable and the local video monitor (if present) to the DRAC 4/P in PCI slot 4.
The DRAC 4 provides a dedicated 10/100 Mbps RJ-45 NIC and a connector for mounting the
card to the system board. The DRAC 4/P also provides a video connector, and a 30-pin
Management Connector.

DRAC 4 Ports

Table 1-2 identifies the ports used by the DRAC 4. This information is required when opening
firewalls for remote access to a DRAC 4.
Table 1-2. DRAC 4 Port Numbers
DRAC 4 Port Number Used For
Ports on DRAC 4 listening for connection (server):
22 Secure Shell (configurable)
23 Telnet (configurable)
80 HTTP (configurable)
161 SNMP Agent (not configurable)
443 HTTPS (configurable)
3668 Virtual Media server (configurable)
5869 Remote racadm spcmp server (not configurable)
5900 Console Redirection (configurable)
23
DRAC 4 Overview