Table of Contents
Advertisement
Operating Instructions
Setting
Enable Image
Buffer/Transfer
Trigger
Alarm enable
condition
4.
Set the time, and click [Next>].
Note
The timer works by an internal clock. Set the date and time before using timer
buffer/transfer (see page 64).
•
Clicking [<Back] takes you back to the previous page.
•
Clicking [Cancel] takes you back to the Trigger page without saving
changes.
Setting
A day of the
week
Active Time of
Trigger
92
•
Check the box to enable the Trigger setting. Clear the box
to disable it.
•
Selecting [Timer] enables this product to buffer/transfer the
image by timer.
•
Selecting [Alarm] enables this product to buffer/transfer the
image by alarm signal.
•
Selecting [Motion Detection] enables this product to
capture/transfer the images when the motion detects
something.
•
Selecting the method of the detection for an alarm
connected to the External I/O terminal.
•
Select [Rising: GND to Open (High).] or [Falling: Open
(High) to GND.]. [Rising: GND to Open (High).] is the state
that GND pin and pin 1 or pin is left open.
[Falling: Open (High) to GND.] is the state that GND pin
and pin 1 or pin is short-circuited. (See page 143)
•
Check the box to enable the day. Clear the box to disable it.
•
Select the [Always] option when you do not specify the time
period. If you specify the time period, select the time period
option and set the time period.
Description
Description
Advertisement
Table of Contents
