Table of Contents
Advertisement
Setting
Display
IP Address
or
*1
Host Name
*2
Port No.
Camera Name
*3
*1
In IPv4, set 4 digits (0—255) and 3 periods such as "192.168.0.253". But
"0.0.0.0" and "255.255.255.255" are not available.
In IPv6, set the host name.
*2
Enter ASCII characters for the host name (see page 163). But [Space], ["], ['],
[#], [&], [%], [=], [+], [?], [<] and [>] are not available.
Enter 1—255 characters.
Enter ASCII characters (see page 163) or characters in each language (1—15
*3
characters for a 1-byte character and 1—7 characters for a 2-byte character).
But [Space], ["], ['], [#], [&], [%], [=], [+], [?], [:], [<], and [>] are not available.
Notes
•
Set the local IP address and port number for this product on the same
LAN.
•
If this product is accessed from the Internet, be sure to use the global IP
address. In this situation, local IP addresses such as
192.168.
4.
Click [Save] when finished.
•
New settings are saved.
•
The Multi-Camera Setup page is displayed.
•
Check the box to enable the image display.
•
Set the IP address or the host name to enable the image
display.
•
Set the port number (1—65535).
•
The name is displayed only on the Multi-Camera page.
.
cannot be used.
[For assistance, please call: 1-800-272-7033]
Description
Operating Instructions
127
Advertisement
Table of Contents
