Wiring - Mitsubishi Electric 800 Series Instruction Manual

3.2

Wiring

Use the network connection cable which supports 12.0 Mbps communication.
1.
Strip off the sheath of the PROFIBUS communication dedicated cable and wind wires and shield cables to use.
Strip the signal wires as follows. If too much of the wire is stripped, a short circuit may occur with neighboring wires. If not
enough of the wire is stripped, wires may become loose and fall out.
Twist the stripped end of wires to prevent them from fraying. Do not solder them.
Use a crimp terminal as necessary.
When using the crimp terminal, make sure that the stranded wire do not come out of the terminal.
20
WIRING
Wire strip length
5 mm
Damaged Crumpled tip
Unstranded
wires
Wires are not inserted
into the sleeve