Dell VxRail VD-4510c Manual page 21

Change the boot order
You may have to change the boot order if you want to boot from a USB drive or an optical drive. The following instructions may
vary if you have selected BIOS for Boot Mode.
NOTE: You can change the drive boot sequence only in BIOS boot mode.
1. From the System Setup Main Menu, click System BIOS > Boot Settings > UEFI Boot Settings > UEFI Boot
Sequence.
2. Use the arrow keys to select a boot device, and use the plus (+) and minus (-) sign keys to move the device down or up in
the order.
3. Click Exit, and then click Yes to save the settings on exit.
NOTE: You can also enable or disable boot order devices as needed.
Configure network settings
1. To view the Network Settings screen, power on the system, and press F2.
2. Click System Setup Main Menu > System BIOS > Network Settings.
NOTE: Network settings are not supported in BIOS boot mode.
3. Use the following table to configure network settings:
Option
UEFI PXE Settings
PXE Device n (n = 1–4)
PXE Device n Settings(n = 1–4)
UEFI HTTP Settings
HTTP Device n (n = 1–4)
HTTP Device n Settings (n = 1–4)
UEFI iSCSI Settings
The following table provides the details of the options available on the UEFI PXE Device n Settings screen:
Option
Interface
Protocol
Vlan
Vlan ID
Vlan Priority
The following table provides the details of the options available on the ISCSI Device1 Settings screen:
Option
Connection 1
Connection 2
Connection 1 Settings
Connection 2 Settings
Connection Order
Description
Enables you to control the configuration of the UEFI PXE device.
Enables or disables the device. When enabled, a UEFI PXE boot option
is created for the device.
Enables you to control the configuration of the PXE device.
Enables you to control the configuration of the UEFI HTTP device.
Enables or disables the device. When enabled, a UEFI HTTP boot option
is created for the device.
Enables you to control the configuration of the HTTP device.
Enables you to control the configuration of the iSCSI device.
Description
Specifies NIC interface that is used for the PXE device.
Specifies Protocol that is used for PXE device. This option is set to IPv4 (default) or IPv6.
Enables or disables (default) VLAN for PXE device.
Shows the VLAN ID for the PXE device
Shows the VLAN Priority for the PXE device.
Description
Enables or disables (default) the iSCSI connection.
Enables or disables (default) the iSCSI connection.
Enables you to control the configuration for the iSCSI connection.
Enables you to control the configuration for the iSCSI connection.
Enables you to control the order for which the iSCSI connections are attempted.
Pre-operating system management applications 21