Kenmore PG-4030400LN User & Care Manual page 9

CAUTION
• Putting out drip fires by closing the lid is not possible.
Grills are well ventilated for safety reasons.
• Do not use water on a drip fire. Personal injury may
result. If a drip fire develops, turn knobs and gas
cylinder off.
• Do not leave the grill unattended while preheating
or burning off food residue on HI. If the grill has not
been regularly cleaned, a drip fire can occur that
may damage the product.
Electronic Ignition Lighting Instructions
▲ Do not lean over the grill while lighting.
1. Open the lid during lighting.
2. Turn ON the gas valve on the gas cylinder.
3. Push, turn, and hold any main burner control knob
to HI when attempting to ignite the burners. You
will hear a clicking sound from the electrodes of all
burners.
4. If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes, and repeat
the lighting procedure.
5. To ignite another burner, repeat step 3.
6. Once burners are lit, adjust the knobs to the
desired flame setting. To extinguish an individual
burner, turn its knob to OFF.
If the igniter does not work, follow the Match Lighting
instructions below.
WARNING
Turn your controls, gas source or gas
cylinder OFF when not in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Match Lighting Instructions
▲ Do not lean over the grill while lighting.
1. Open the lid during lighting.
2. Place the match into the match holder (hanging on
the left side panel).
3. Light the match and insert the match holder through
the lighting in the side of the firebox.
4. Place the lighted match next to a burner. Turn the
burner knob to HI position. Be sure the burner lights
and stays lit.
5. To light the other burners, repeat step 3 & 4.
6. Once the burners are lit, adjust the knobs to the
desired flame setting. To extinguish any individual
burner, turn its knob to OFF.
Burner Flame Check
• Remove the cooking grates and heat diffusers. Light
the burners and rotate the knobs from HIGH to LOW.
You should see a smaller flame on the LOW setting
and a higher flame on the HI setting. Always check
the flame prior to each use. If only low flame is seen,
refer to the "Sudden drop or low flame" in the
Troubleshooting Section on page 34.
Turning Grill Off
• Turn all knobs to the OFF position. Turn the gas
cylinder off. When you are finished grilling, raise the
grill lid to allow the grill to fully cool. If the grill lid is
closed while the grill is cooling, condensation may
occur on the interior grill surfaces which can cause the
interior parts to rust.
Igniter Check
• Turn the gas cylinder off. Press and hold the electronic
igniter button. "Click" should be heard and sparks
should be seen each time between the collector box
or burner and electrode. See the Troubleshooting
Section on pages 33-35 if there are no clicks or
sparks.
9