3. With each bullet identified, land the non-bullet side to the corresponding feature on the
EntelliGuard R's 78-point secondary disconnects. (See Error! Reference source not found.
Page Error! Bookmark not defined..)
If a wire is too long, cut the wire, crimp a new connector, and install the provided wire markers on the
bullets. Refer to Error! Reference source not
Figure 46. Example Wiring Diagram for AK25 Secondary Disconnects and Photo Example
Below are tables
(Table 7
secondary-disconnects.
36 EntelliGuard R Circuit Breaker Retrofill AKD-5 Installation Manual
found., Page Error! Bookmark not
and
Table
8) featuring the two 39-blocks (A and B). They make up the 78-point
on
defined..
DEH-41547