Using The Safety-Interlock System - Toro Z Master Professional 6000 Series Operator's Manual

Stopping the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Let the engine idle at slow throttle (in the rear position) for
60 seconds before turning the ignition switch off.
G008947
Figure 19
Figure 20
Important: Make sure that the fuel shut-off valve is
closed before transporting or storing the machine, as
fuel leakage may occur. Set the parking brake before
transporting. Make sure to remove the key as the fuel
pump may run and cause the battery to lose charge.
Using the Safety-interlock
System
CAUTION
If safety-interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Understanding the Safety-interlock
System
The safety-interlock system is designed to prevent the engine
from starting unless:
•
The parking brake is engaged.
•
The blade-control switch (PTO) is disengaged.
•
The motion-control levers are in the neutral-locked
position.
The safety-interlock system also is designed to stop the
engine when the traction controls are moved from the locked
position with the parking brake engaged or if you rise from
the seat when the PTO is engaged.
The hour meter has symbols to notify the user when the
interlock component is in the correct position. When the
component is in the correct position, a triangle will light up
in the corresponding square.
G009181
1. Triangles light up when the interlock components are in the
correct position
22
Figure 21
1