Toro Z Master Professional 6000 Series Operator's Manual page 38

Changing the Engine Oil
Service Interval: After the first 8 hours
Every 100 hours (more often in dirty or dusty
conditions).
Note: Dispose of the used oil at a recycling center.
1. Start the engine and let it run for 5 minutes.
Note: This warms the oil so it drains better.
2. Park the machine so that the rear is slightly lower than
the front to ensure that the oil drains completely.
3. Disengage the PTO, move the motion-control levers to
the neutral-locked position, and set the parking brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 49).
1
3
4
Figure 49
G008804
2
4
5
G008793
5. Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil to
bring it to the Full mark (Figure 50).
1
3
5
6. Start the engine and drive to a flat area.
7. Check the oil level again.
38
2
4
6
G008796
Figure 50