Advertisement
8. Note for assembly
(1) Chassis B unit check
fe ike
Insert the reset spacer/reset rubber.
* While pushing slier B ®, slide battery replacement SW @ to the
left edge and fix it temporarily.
Check that reset rubber @ and reset spacer @ are inserted as
shown in the figure. (No need to consider the rear and the surface
of the reset spacer.)
(2) Coil spring attachment
Slider 8
*Fix the coil spring to the projection.
= Coil spring
\
8
Slider B attachment
The coil spring must be
on this guide
{Insertion into shassis 8)
=a
(3) PWB and chassis B unit attachment
Fix chassis B unit © to PWB unit @ with three screws @,
(Set the screws at positions marked with 4.)
(4) Speaker attachment and lead wire treatment
© insert speaker mesh © into the center of the speaker hole before
attaching speaker @).
'When attaching the speaker, slightly press the center to install
horizontally and fix it with two screws @).
(GOOD)
(Insutficient screw tighteni
Advertisement
