Feature Operation; Login/Logout - NEC UNIVERGE SV9300 User Manual

FEATURE
OPERATION
This chapter describes how to login/logout, how
to input characters and how to make a call/hold,
etc.

LOGIN/LOGOUT

TO LOGIN
When login mode is activated, the terminal
prompts for Login ID and Password.
When the terminal starts up with displaying the
below screen, the Login Mode is activated.
1.
The terminal is starting up with
Login Mode.
2.
Enter Login ID.
For example, the extension number 200 is
pressed.
As initial setting, enter the extension
number as Login ID.
Up to 16 characters can be entered
for Login ID.
 After entering Login ID, press Soft key
(Set).
3.
Enter a password.
As initial setting, enter the extension
number as password.
From 4 to 10 characters can be
entered for a password. The entered
password is displayed in "*".
 After entering a password, press Soft
key (OK).
4.
If the Login ID and Password are
accepted, display changes to
normal idle status.
The terminal becomes available.
MARY SMITH
11:00 AM SUN 1 JUN 2014
MIC
If you enter the wrong ID and/or
password, normal screen is not
displayed and return to [Login] screen.
In this case enter the correct "Login
ID" and "Password"
TO LOGOUT
The terminal which is operated with Login Mode
can log out. Logout operation is as follows.
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
2.
Press Logout feature key.
Logout feature key can be set by means
of system data setting. For details,
please contact the system
administrator.
60

FEATURE OPERATION

[200]
DIR HIST. >>>>