Husqvarna EPOS RS1 Operator's Manual page 21

Message
Empty battery
Map problem
Searching for position
Boundary wire problem
2211 - 002 - 30.11.2023
Cause
The product cannot find the charging sta-
tion.
The battery is at the end of its life cycle.
The antenna of the charging station is
defective.
There is no specified work area.
The map object file is incorrect.
Weak satellite signal to the reference sta-
tion.
Weak satellite signal to the product.
The boundary wire is damaged or not in-
stalled correctly.
Action
The product has no accurate position
and cannot find the charging station.
There is an obstacle that prevents the
product to find the charging station.
Replace the battery.
If the LED indicator on the charging
station flashes red, the antenna of the
charging station is defective. Speak to
your approved servicing dealer.
Make a work area in the Automower
To make a work
Connect app. Refer to
area on page 17 .
Do a check of the map in the app. Adjust
the map and save it.
Delete the map and do a new installation.
The satellite signal is temporary weak.
The product will start to operate when the
satellite signals are good.
Examine the installation of the reference
station..
The satellite signal is temporary weak.
The product will start to operate when the
satellite signal are good.
Examine if there is an object between
the product and the sky that cause inter-
ference with the satellite signal. Remove
the object or do a new installation to not
include these parts in the work area. Re-
Installation of the map objects on
fer to
page 15
Install boundary wire to operate with the
EPOS system in the work area. Refer to
To use the EPOS Support by wire func-
tion on page 11 .
Examine that the boundary wire is con-
nected correctly to the charging station.
Examine all splices on the boundary
wire. Examine if the boundary wire is
damaged and repair it if it is necessary.
Troubleshooting - 21
®