To make a transport path
•
Operate the product and add waypoints on the
map to install a transport path. Start in a work area
minimum 1 m / 3.3 ft. from the virtual boundary.
•
Install the transport path perpendicular to the
virtual boundary of the work area.
•
Do not install a transport path across a stay-out
zone.
•
Do not set waypoints that make the transport path
go across the same transport path.
•
Do not make sharp bends when you install the
transport part.
135º
135º
•
Operate the product and add waypoints to connect
the transport path to the docking point.
•
Put the last waypoint on a transport path (A) in
an angle of +/-45 degrees seen from the docking
point.
A
•
Save the transport path to automatically connect
the last waypoint to the docking point.
•
Set the corridor width (A) for the transport path.
The corridor width can be set to 2-5 m / 6.6-16.4 ft.
18 - Installation
To make a maintenance point
•
Operate the product and add waypoints on the
map. Start to add waypoints at the position
where you install the maintenance point. The first
waypoint specifies the maintenance point.
•
Do not make sharp bends when you install a
transport part.
<90º
•
Operate the product and add waypoints to make a
path to the charging station.
•
Put the last waypoint on a transport path (A) in
an angle of +/-45 degrees seen from the docking
point.
•
Save the maintenance point to automatically
connect the last waypoint to the docking point.
•
Set the corridor width (A) for the maintenance
point. The corridor width can be set to 2-5 m /
6.6-16.4 ft.
A
135º
135º
A
2211 - 002 - 30.11.2023
B
<90º