Husqvarna EPOS RS1 Operator's Manual page 10

D
D
E
• Make sure that the areas between objects have a
distance (F) of minimum 4 m / 13 ft.
F
Note:
For areas with a width less than 4 m / 13
ft. a transport path can be made for the robotic
lawn mower to go through without cutting.
3.9.1 Passages
A passage is a section that has virtual boundary on each
side and that connects 2 parts of the work area. The
width of the passage can be minimum 2 m / 6.5 ft. to get
a good cutting result.
10 - Installation
D
D
3.9.2 To examine where to make stay-out
zones
• Make stay-out zones around objects that are larger
than 2x2 m / 6.6x6.6 ft.
• Make sure that the stay-out zone includes the
complete area were the product must not operate
(B).
Note:
Do not make a stay-out zone across the
work area to prevent the product to enter parts of
the work area (A).
• Make sure that the stay-out zone is minimum
30x30 cm / 1x1 ft.
3.9.3 To install the map objects in a slope
Slopes that are too steep must be isolated with the
boundary wire. The gradient (%) is calculated as
the vertical height divided by the horizontal distance.
Example: 10 cm / 100 cm = 10%.
10%
10 cm/4"
• For slopes steeper than the maximum permitted
slope, do not include them in the work area. You
can also isolate the slope with a stay-out zone.
• Install the virtual boundaries in slopes that are less
steep than the maximum permitted slope for the
virtual boundary.
• For slopes adjacent to a public road, put a barrier
of minimum 15 cm / 6 in. along the outer edge of
the slope. You can use a wall or a fence as a
barrier.
• For systematic pattern, Husqvarna recommends
that you set the direction of the systematic pattern
straight up the slope.
A
B
100 cm/40"
2211 - 002 - 30.11.2023