Table of Contents
Advertisement
(4) Exiting the simulation mode
To exit the simulation mode, click the End button or Close botton.
then, this equipment shutdown automatically.
Alternatively,exit the simulation mode in the following cases(reasons).
・Shutdown is executed on the Start menu.
・A system shutdown API function such as the BSSysshut and ExitWindowsEx
functions is executed.
・The equipment is automatically shut down because fan failure, abnormal
temperature inside the chassis, or a remote shutdown signal input is detected.
・Ctrl + Alt + Delete is pressed and using the power button at the lower right corner of
the screen, the equipment is shut down.
・A blue screen appears because, for example, the reset button is pressed.
・The power is forcibly turned off using the power switch.
NOTE
・As explained above, the simulation mode exits when the equipment shutdown
or restart
To start the simulation mode again, execute the simulation mode
.
start command after restart.
・When you execute shutdown or logoff in the simulation mode, the following
message is displayed to notify that the simulation mode will exit and that the
system will shut down.
・When a remote connection is used, shutdown process can be delayed when
shutdown is executed due to a reason listed above.
8. SIMULATING THE HARDWARE STATUS
8-15
Advertisement
Table of Contents
